.jpg)
.jpg)
I have too many computer cables and some get lost or misplaced, so I decided to make some wooden labels for them. I will make them is such a way so I can lock them. I will take the cables I use most and lock them on my desk or anywhere I need too.
To start I cut some 17 inch long oak into strips using my ripping jig.
They are cut at 4.17 mm.
On my miter sled I will cut them to length... 2 1/2 inch blanks.
A 1/2 inch Forstner bit is used to make the hole for the lock cable.
I use my horizontal drill for the holes for the cables. Two blanks are stacked and clamped ready for drilling. An 11/64 inch drill bit is used and the cable slides free in the hole.
They are now glued and clamped and set aside. Later I light sand, chamfer the hole and round the corners on a small belt sander all the while watching not to touch the cable.
If ever I need to take them apart they can be placed in the vice and tapped carefully with a screw driver and pried apart. I tried one and there was no problem, although the glue was quite strong.
See also:
Make a Mini Lathe Table saw jig for edge banding and ripping

.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
On your video about how to make a mini lathe, on the 2:31 (leveling the drill), you used ¿what tool? to verify the distance to surface?
ReplyDeleteBTW:
great videos! even more! whet you make a thing, it seems to be an simple, easy thing to do...
To make sure the drill was positioned properly I inserted a long rod into the chuck of the drill and used a telescoping gauge for accuracy to align the drill.
ReplyDeleteBA4C05D700
ReplyDeletekiralık hacker
hacker arıyorum
kiralık hacker
hacker arıyorum
belek
34F1E3B0
ReplyDeleteYozgat
Kastamonu
Yalova
Ardahan
Adıyaman
Elazığ
Aksaray
Amasya
Konya
Çorlu
ReplyDeleteGaziemir
Fethiye
Foça
Gölcük
Söke
Kapaklı
Çerkezköy
Bandırma